Mmf-pos USB with Statistics and 4 Port Hub Combo Interface Manual do Utilizador descarregar pdf

USB Interface /USB-HUB Combo Interface Instruction manual / User Guide

Approved Date of Revision 5/1/2010 Doc. Instruction Manual

P/N: 531911900

USB Interface / USB-HUB Combo Interface

If you have purchased a USB-HUB Combo, proceed by always connecting the standard USB interface which serves as

the cash drawer’s connectivity first. For both types of interfaces, please follow these steps:

GETTING STARTED:

 Select Cash Drawer Number

The MMO POS USB Interface Board is factory defaulted to recognize the first cash drawer to be

installed as drawer number zero (0), see Figure 1.0 Dip-Switch Position (Default Setting). If user

decides to assign another drawer number, please follow the pin configuration illustrated in SWITCH

SETTINGS Table 1.0 or label attached to the interface for correct pin orientation. MMF recommends

selecting cash drawer number one (1) as your option.

 Connect the Power Supply (12VDC / .8 Amp)

Plug the small plug tip to the interface power port in the back of the cash drawer interface as illustrated in

Figure 1. Plug the power adapter end into a 120 Volt AC Recepticle.

Always connect the power supply before the USB Cable. LED#2 (GREEN) and LED#5 (RED) should be ON

at this time, refer to Table 2.0 for reference.

 Connect USB Cable

Plug the T ype B connector e nd to the U SB Po rt o f the i nterface a s i llustrated i n F igure 1 a nd the T ype A

Connector to the USB port of the Host Computer. ALL the LED except LED#4 (GREEN) should be ON at this

time. Refer to Table 2.0 for LED State.

 Test Functionality of Interface

Follow the steps detailed below for ‘USB Test Utility Installation’.

 Install OPOS Drivers

Follow the steps detailed below for ‘MMF OPOS Drivers Installation’.

NOTE: Do not assign two (2) USB interface cash drawers within the same system with the same cash drawer number.

FIGURE 1.0

TABLE 1.0

SWITCH

SETTINGS

DRAWER

DIP-SWITCH

SW1

ON OFF ON OFF ON OFF ON

OFF

SW2

ON ON OFF OFF ON ON OFF

OFF

SW3

ON ON ON ON OFF OFF OFF

OFF

SW4

RESERVED

Note: OFF is when pins are facing down (↓). ON is when pins are facing up (↑).

LEDS

DIP-SWITCH POSITION

Default Setting: Drawer 0

Power Port

Connect 12V DC

Power Supply

Here

USB Port

Port of Cash Drawer

Interface

Connect Type B

Connector of USB

cable Here

This light should not be ON at

any time

USB Interface

P/N#2261998USBA1-XX:

USB Interface KIT (Includes Power

Supplies & USB Host Cables)

P/N# 641-2575-00:

Cash Drawer Power Supply (12V dc)

P/N# 641-25BX-00:

USB Host Cable

USB-HUB Combo Interface

(A combination of our standard USB

Interface and a 4-Port HUB)

P/N# 2261998USBA1-XX:

USB-HUB Interface KIT (Includes Power

Supplies & USB Host Cables)

P/N# 641-2575-00:

Cash Drawer Power Supply (12V dc)

P/N# 641-25CE-00:

USB Hub Power Supply (5V dc)

P/N# 641-25BX-00:

USB Host Cable

1 2 3 4 5

Information 5

Resumo do Conteúdo

Página 1

USB Interface /USB-HUB Combo Interface Instruction manual / User Guide

Página 2

USB Interface /USB-HUB Combo Interface Instruction manual / User Guide

Página 3

USB Interface /USB-HUB Combo Interface Instruction manual / User Guide

Página 4

USB Interface /USB-HUB Combo Interface Instruction manual / User Guide

Página 5 - Information

USB Interface /USB-HUB Combo Interface Instruction manual / User Guide

Comentários a estes Manuais

Sem comentários

Mmf-pos USB with Statistics and 4 Port Hub Combo Interface Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware Mmf-pos USB with Statistics and 4 Port Hub Combo Interface. MMF POS USB with Statistics and 4 Port Hub Combo Interface Kit User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Mmf-pos USB with Statistics and 4 Port Hub Combo Interface